Circutor CVM-C10 Series Instrukcja Użytkownika Pobierz pdf (Strona 48)

4�9�21� Cost Ratio of consumed energy

The cost per kWh of electricity of the three tariffs of the unit is

calculated on this screen.

Press key

for 3 seconds to edit the cost ratio selection. The

prog icon will be displayed on the bottom of the screen.

To enter or modify the value, press the

key repeatedly,

increasing the value of the ashing digit.

When the desired value is shown on the screen, move onto the next digit by pressing the key

to modify the other values.

If you press the key after changing the last digit, it will jump back to the rst digit so you

can modify the previously programmed values again.

Press key to browse the different tariffs.

To validate the data, press for 3 seconds and the prog icon will disappear from the display.

The programmed value will be deleted if the entered value is higher than the maximum

programming value.

Maximum programming value: 1.9999.

Minimum programming value: 0.

Press key to access the next programming step.

4�9�22� Programming alarm 1 (Relay 1)

The variable code is selected on this screen, depending on Table

12,

which will control alarm relay 1.

Press key

for 3 seconds to edit the code selection. The prog

icon will be displayed on the bottom of the screen.

To enter or modify the value, press the key repeatedly, increasing the value of the ashing

digit.

When the desired value is shown on the screen, move onto the next digit by pressing the key

to modify the other values.

When you enter the code of a variable on the display, the symbols for that variable will be

activated.

Set the value to 00 if you do not wish to program a variable.

CVM-C10

Instruction Manual

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 81 82

Brak uwag

Circutor CVM-C10 Series Instrukcja Użytkownika Strona 48