Circutor PowerStudio Series Instrukcja Użytkownika Pobierz pdf (Strona 240)

PowerStudio PowerStudio

240 User Manual

1.62.- TCP1RS+

The TCP1RS+ converter connects units that work with RS-485 serial communication to an

Ethernet network using the IP protocol.

Check ‘Manual Editor’ when this device is added or modified; the following dialog box will be

displayed:

• Name: Alphanumeric field that uniquely identifies the device throughout the program. There

are no two devices in the configuration with the same name.

• Description: Enter a brief description of the device using alphanumeric data.

• Converter address: Corresponds to the address the program uses to communicate with the

device. This parameter can be an IP address or a name. This address should not be confused

with the MAC address.

• Connection: Indicates whether the connection is UDP, TCP or Modbus TCP.

• Port: Corresponds to the communications port.

• Configuration port: Corresponds to the communications port the program uses to configure

the device. The default port is 2000.

Follow these steps so that the TCP1RS+ device can communicate through a router:

1 - In the ‘Address converter‘ field enter the router's IP address.

2 - In the ‘Port” field enter the communications port and redirect this port on the router to the

device's communications port.

3 - Redirect the configuration port on the router to port 2000 of the converter.

NOTE: For information on readdressing ports consult the router user manual.

• Parameters: Clicking on this button will open a dialogue box, where a number of parameters

of the device can be configured.

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 291 292

Brak uwag

Circutor PowerStudio Series Instrukcja Użytkownika Strona 240